[Discuss] Tunnel

[Walter Ring]

Ok, da hast du natürlich recht.

Meiner broadcasted jetzt brav:

(spam-protected):/etc# tcpdump -ni tap0
tcpdump: verbose output suppressed, use -v or -vv for full protocol decode
listening on tap0, link-type EN10MB (Ethernet), capture size 68 bytes
01:01:45.785627 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
20
01:01:55.355490 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
20
01:01:58.181227 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
24
01:01:58.721252 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
64
01:02:06.365403 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
20
01:02:17.335403 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
20
01:02:28.175415 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
100
01:02:38.155473 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
20
01:02:48.155402 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
20
01:02:55.791229 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
84
01:02:59.955483 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
20
01:03:11.395394 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
20
01:03:20.795406 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
20
01:03:23.621859 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
24
01:03:26.081164 IP 193.238.158.109.698 > 193.238.158.111.698: UDP, length:
64

15 packets captured
15 packets received by filter
0 packets dropped by kernel
(spam-protected):/etc#

Aber olsr-Routen lernt er immer noch nicht:

(spam-protected):/etc# route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use
Iface
193.238.156.1   10.0.0.1        255.255.255.255 UGH   0      0        0
vlan1
193.238.158.104 *               255.255.255.248 U     0      0        0 tap0
193.238.156.0   *               255.255.252.0   U     0      0        0
vlan0
193.238.156.0   *               255.255.252.0   U     0      0        0 eth1
10.0.0.0        *               255.255.0.0     U     0      0        0
vlan1
(spam-protected):/etc#

Seh nur outgoing und keinen incoming Traffic vom Tunnel-Gateway.

lg walter

-----Original Message-----
From: (spam-protected)
[mailto:(spam-protected)] On Behalf Of Andreas
Marksteiner
Sent: Sonntag, 06. November 2005 19:04
To: Walter Ring
Cc: (spam-protected)
Subject: Re: [Discuss] Tunnel

fehler entdeckt:

> export FF_olsrd_interfaces="vlan0 eth1"

das tunnel device "tap0" muss da noch dazu, sonst kann das schon mal  
nicht gehen -->

export FF_olsrd_interfaces="vlan0 eth1 tap0"